audiophony Atom12A Kullanıcı Kılavuzu - Sayfa 5

Konuşmacılar audiophony Atom12A için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. audiophony Atom12A 12 sayfaları.

ATOM series - 2 ways 10/12/15" powered full range speaker and 15/18" powered subwoofer with DSP
8
Channel 1 input level
Make sure that the input level is not too high to avoid
distorted sound.
9
Channnel 2 input level 2
Make sure that the input level is not too high to avoid
distorted sound.
10
Auxiliary Input
Stéréo 3.5 jack.
This input is used to connect a tablet, a mobile phone,
an MP3 player,... etc.
11
RCA line input
This input is used to retrieve a signal from a CD player,
a mixer, etc...
ATOM10A/12A/15A input setting
1 - Connect the loudspeaker to the mains via IEC plug / 2-pin + earth. Leave the power switch (2) in the
OFF position.
2 - Set all LEVEL potentiometers (8 and 9) to the -
3 - Connect your microphone or line level source or both. L'entrée ligne est accessible par le branchement
The line input can be accessed via a 3-pin 6.35 mm (TRS) jack, RCA LINE IN or AUX input. To acces
to the microphone preamplifier, use the XRL plug
4 - Switch on the line level source.
5 - Switch on the ATOM speaker.
6 - While you are speaking in a microphone or an audio signal is being played from your line-level source,
turn the input level knob (s) until the display shows "Limit Signal", then turn it down just below that
level.
7 - If you use a microphone, be careful not to stand too close to the speaker as this may result in
feedback. If you do not use both inputs, it is recommended that you leave the level knob on the
unused input at the -
position to prevent noise from entering the signal circuit.
position.
Page 5