Addonics Technologies RCHDSAES Kullanıcı Kılavuzu - Sayfa 2

Depolama Addonics Technologies RCHDSAES için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Addonics Technologies RCHDSAES 4 sayfaları. Ruby combo hard drive

Sayfayı Yazdır

Step 4 Turn over the PCB and secure the hard drive to the PCB with the

mounting screws that come with the kit.

Step 5 Mount the board to the bottom cover.

Step 6 Put the top cover on by holding it in near vertical position and sliding the

two metal clips inside the two small slots on the rear of the bottom cover.

Step 7 Lower the front of the top cover and making sure the two covers lined up

properly. Tighten the small retaining screw on the front of the bottom cover to

close the enclosure.

Ruby Enclosure

Switch

Power LED and

Drive Access LED

Switch:

INT: This mode is used when the enclosure is placed inside a drive

cradle. For mobile rack kits, this is the mode used.

EXT: This mode is used if the enclosure is used as an external hard

drive.

Ruby Drive Cradle

Note: You can only use one power connector at a time. Either use the 4-pin

Molex or 15-pin SATA connector but not simultaneously use them.

15-pin SATA

7-pin SATA

power connector

data connector

4-pin Molex

power connector

Mounting holes for

3 ½" drive bay