Consonance Droplet LP3.1 Kullanıcı Kılavuzu - Sayfa 3

Pikap Consonance Droplet LP3.1 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Consonance Droplet LP3.1 6 sayfaları.

3.Put the bearing housing very gently down over the shaft taking care not to displace the ball. It will be a very

tight fit but once engaged it can drop suddenly - lower the bearing housing carefully by hand to prevent this.

Now spin the bearing to ensure it runs smoothly.

If it's not smooth enough, use the syringe to fill the small hole at the top of the spindle. Once you've done this

turn the bearing whilst gently lifting the bearing housing. The oil will disappear into the bearing and wash down

the shaft. Because of the very tight clearances of the bearing there may still be small amounts of 'friction' - this

will disappear as the bearing runs in.

4. Put on the cotton gloves and

pick up the acrylic platter, with the

dip for the record label uppermost.

Hold it level over the bearing

housing, locate it carefully and

gently lower it until it seats fully

over the bearing.

5. Take out one of the drive 'belts' and run it round the motor spindle and then round the platter. There are two

ruts on the pulley of motor. The above rut is for 45 rpm, and the nether rut is for 33.3 rpm. Different ruts for the