BELFORNO 32 Kurulum ve Kullanım Talimatları Kılavuzu - Sayfa 14

Ticari Gıda Ekipmanları BELFORNO 32 için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Talimatları Kılavuzu indirin. BELFORNO 32 14 sayfaları. Commercial and residential wood fired ovens

Sayfayı Yazdır

8. ENSURE A TIGHT FIT.

There are intentional gaps between pieces but the dome components should be

made to fit as tightly as possible. To achieve this, stand on top of the base. Reach

into the top center hole, and carefully lift each dome piece, while another person

applies pressure to the bottom of the piece, towards the center of the oven.

Continue to do this until all pieces are as tight as possible.

9. FILL THE OUTSIDE GROOVES (BELFORNO56 ONLY).

When the oven is fully assembled, there will be intentional grooves of approximately

¼" between the outside edges of the dome segments. Fill these with the brown

Belforno putty, supplied. The putty can be rolled between the hands into "snakes",

and pressed into place.

10. FINISH THE ENTRANCE WITH A LITTLE MORTAR.

For aesthetic appeal, it may be preferred to fill gaps in the hearth area where the

floor meets the wall.

11. NOTE WELL: SEAL THE OVEN.

Never let the insulation get wet. Always thoroughly seal the exterior and chimney

against water penetration. Failure to do so can lead to breakdown of components.

Commercial and Residential Wood Fired Ovens

Version 1.8

Installation and Operating Instructions