Conspit CGP Hızlı Kılavuz - Sayfa 6

Müzik Pedalı Conspit CGP için çevrimiçi göz atın veya pdf Hızlı Kılavuz indirin. Conspit CGP 10 sayfaları.

Rubber replacement demonstration for CPP series

* Due to the ductility of the piston material inside the hydraulic

cylinder,CPP brake need to be used for a period of time to

eliminate the sense of resistance caused by friction.

Cylinder(a)

rubber and washers combination （g）

1. Loosen the adjusting ring (d) counterclockwise;

2. Unscrew the cylinder closure knob (e), slightly press the brake pedal to take out the

rubbers (c) and washers (b)；

3. Dip an appropriate amount of lubricating oil with a cotton swab, apply it to the two

ends of the new rubber to be replaced and its edges, and seal both ends of the rubber

with gaskets of the corresponding size. The washer and the rubber are adhered to

each other by the viscosity of the lubricating oil, and put the two washers and one

rubber into the cylinder as a whole(g)；

4. After properly ﬁtting the rubbers (c) and washers (b), install the cylinder closure

knob (e) and adjusting ring (d)；

5. Turn the adjusting ring (d) clockwise to increase the initial stiﬀness and shorten the

pedal travel range; turn the adjusting ring (d) counterclockwise to decrease the initial

stiﬀness and increase the pedal travel range.

Washer(b)

PU rubbers(c)

Adjusting ring(d)

Cylinder closure knob(e)