DanVex HUM-3S Kullanım Kılavuzu - Sayfa 6

Nemlendirin DanVex HUM-3S için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. DanVex HUM-3S 11 sayfaları. Ultrasonic humidifiers

1. The humidifier is switched on, the transducer (oscillator) membrane is in positive position; 2. Transducer

membrane is in negative position, vacuum is generated due to inertia of the water; 3. After ten

Product design

Front removable panel: used for air filter replacement; for inspection, maintenance and

repair of the humidifier electrical components;

Top removable panel: used for maintenance of piezoelectric transducers and float valve

system;

Steam pipe socket: used for connection of the output steam pipes (not included);

Main controller: used for display of the current humidity level and for setting of required

humidity level;

Drain valve: used for water draining from the humidifier before maintenance works and

during standstill;

Water supply fitting: used for the supplied demineralized water (pressure of 1-4 atm.);

Water overflow fitting: used for overflow prevention;

Power cable entry: used for the humidifier power supply;

Mode selector switch: used for selection of the humidifier operating mode (switched off –

automatic mode – manual mode);

Humidity sensor connector: used for connection of remote humidity sensor;

Replacement air filter: used for incoming air treatment.

Fig. Water mist generation stages (from left to right):

membrane oscillations the humidifier reaches its maximum capacity.

1. Front removable panel

2. Top removable panel

3. Steam pipe socket

4. Main controller

5. Drain valve

6. Water supply fitting

7. Water overflow fitting

8. Power cable entry

9. Mode selector switch

10. Humidity sensor connector

11. Marking

12. Replacement air filter