Audiotec Fischer PP 62DSP Kullanıcı Kılavuzu - Sayfa 13
Amplifikatör Audiotec Fischer PP 62DSP için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Audiotec Fischer PP 62DSP 16 sayfaları. Extension card
Ayrıca Audiotec Fischer PP 62DSP için: Kurulum Talimatları (2 sayfalar)
Sayfayı Yazdır
Installation of a MATCH Extension Card
®
Bluetooth
Audio Streaming module, an optical dig-
ital input or an AUX input.
to remove the side panel of the PP 62DSP and re-
place it by the new side panel that comes with the
MEC.
Attention: Install the MEC module only in the
the MEC module in other devices or slots can
result in damage of the MEC module, the ampli-
devices!
Read in the following the steps how to install a MEC
module:
1. First disconnect all cables from the device.
2. Dismantle the side panel where the USB input
is located by removing the Phillips screws.
3. Pull out the bottom plate.
4. Prepare the module for installing it into the de-
vice. Any further mounting information will be
found in the instruction manual of the respective
MEC module.
the device which is marked in the following pic-
ture.
26
6. Make sure that the MEC module is installed
-
properly and all pins are fully inserted into the
socket.
panel which is delivered with the MEC module
with the Phillips screws.
8. Bolt the MEC module to the side panel. Pre-
cise mounting information will be found in
the instruction manual of the respective MEC
module.
9. Reconnect all cables to the device.
matically detected by the device and the Status
LED of the MEC module lights up green.
iary source, whereas in combination with the
software for proper operation.
-
-
-