Addonics Technologies HDUS11NB Kullanıcı Kılavuzu - Sayfa 4
Disk Çoğaltıcı Addonics Technologies HDUS11NB için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Addonics Technologies HDUS11NB 18 sayfaları. 1:11 hdd duplicator nb
Sayfayı Yazdır
Connecting the Power Cable and Powering On
1. Connect the power cord provided from the wall outlet to the back of the tower.
2. Push the power button to turn on the HDD duplicator.
The Duplicator Panel
There are four buttons and an LCD on the panel of HDD Duplicator.
1. LCD shows a function or a message.
2. it is used to scroll up function menus.
3. it is used to scroll down function menus.
4. it is used to execute a function.
5. it is used to cancel a function.
Duplicating a Drive
When the duplicator powers on, it initializes and goes through the steps below
Shows the firmware version
HD Duplicator
1-1 Ver:
Detect Drives' status.
Detect Drives
Copy HDD copies data directly from the source hard disk to the target hard disk.
Press ENT button to begin copy. The system will auto-detect the hard disks and show the following info
on the LCD.
Copy-36MBs 0%
235.7GB
1:48
The LCD will show the following info during the copying process: remaining time, completed percentage.
The copy speed, capacity and time will vary depending on the source hard disk. Once the copying
process is complete the LCD will display the following results.
Copy HD
OK:
www.addonics.com
Duplicator Panel
Initialize SDRAM's status..
Initialize SDRAM
Shows the first function:
1.Copy HD
Technical Support (M-F 8:30am - 6:00pm PST)
Phone: 408-453-6212
Email: www.addonics.com/support/query/
1
2
4
ENT
5
ESC
3