DAPAudio D4203 Kullanım Kılavuzu - Sayfa 10

Amplifikatör DAPAudio D4203 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. DAPAudio D4203 17 sayfaları. Dap audio falcon stage amp series

Sayfayı Yazdır
DAPAudio D4203 Kullanım Kılavuzu

Operation

Installation
Remove all packing materials from the Falcon. Check that all foam and plastic padding is removed.
Secure the equipment into a 19" rack. Connect all cables.
Connecting Power / Circuit Size Requirements.
Make sure the mains voltage Is correct and Is the same as that printed on the rear of the amplifier.
Damage caused by connecting the amplifier to Improper AC voltage Is not covered by any warranty.
Unless otherwise specified when ordered. DAP audio amplifiers shipped to customers are configured as
follows:
NOTE: Always turn off and disconnect the amplifier from mains voltage before making audio
connections. Also, as an extra precaution, have the attenuators turned down during
power-up.
Cooling System and Requirements.
Falcon Series amplifiers use a twin-tunnel forced-air cooling system to maintain a low, even operating
temperature. Drawn In by variable speed fan(s) on the front panel, air flows through the cooling fans of
the channel heat sinks (dissipating power transistor heat), then exhausts through the rear panel slots.
IMPORTANT: To ensure optimum cooling, periodically clean the amplifier fan filters (removable
without tools). Also make certain that there is enough space around the front of the amplifier to allow
the cooling air to
escape.
If the amplifier is rack-mounted, do not use doors or covers on the front of
the rack; the exhaust air must flow out without resistance. If the amplifiers are housed in racks
with closed backs, allow at least one (1) standard rack space of opening In the front of the rack for
every four amplifiers.
Connecting Inputs.
Use the XLR input connectors on the rear to supply audio signals to your DAP Audio Falcon Series
amplifier. The connectors accept balanced and unbalanced audio connections. The Falcon Series
amplifiers are configured standard with "Pin 2 hot" on XLR inputs. The Link connector can be used to loop
the audio Input to another amplifier Input. For more Information, see the section on Connection cables
page 10.
Connecting Outputs.
Speakers are connected using Speakon connectors. For examples see figures 4 and 5.
8