DAPAudio D6140 Manuel - Sayfa 12

Amplifikatör DAPAudio D6140 için çevrimiçi göz atın veya pdf Manuel indirin. DAPAudio D6140 20 sayfaları.

PA-303TU

Operation

Remove all packing materials from the PA-303TU. Check that all foam and plastic padding is removed.

Secure the equipment into a 19" rack if prefered. Connect all cables.

Before plugging the unit in, always make sure that the power supply matches the product specification

voltage. Do not attempt to operate a 115V specification product on 230V power, or vice versa.

Before powering up the first time, make sure the AC-selector switch is set to the proper voltage.

Damage caused by connecting the amplifier to improper AC voltage is not covered by any warranty.

NOTE: Always turn off and disconnect the amplifier from mains voltage before making audio

connections. Also, as an extra precaution, have the attenuators turned down during

power-up.

Use the jack input at the front or the XLR input connectors on the rear to supply audio signals to your DAP

Audio PA-Series amplifier. The jack connectors accept unbalanced audio connections while the XLR

connectors accept balanced and unbalanced audio connections. (The PA- Series amplifiers are

configured standard with "Pin 2 hot" on XLR inputs. For more Information, see the section on Connection

cables on page 15.

Selecting a station

Use the AM/FM (15) button to select either AM or FM band. Press the

(20) or

(21) button to tune

stepwise.

Pushing and holding the

(20) or

(21) button for more than 3 seconds will start auto search.

Selecting a preset.

Use the

AM/FM (15)

button to select either AM or FM band.

Press M1 (16), M2 (17), M3 (24), M4 (27) or M5 (28) to recall preset M1-M5.

Storing a station in Memory

Push the memory (23) button. "Memory" appears in the display and the preset number changes into a

line.

Now press button M1 (16), M2 (17), M3 (24), M4 (27) or M5 (29) to store the preset in the desired memory

location.

Ordercode: D6140