DAQ DVI-CL01 Kullanıcı Kılavuzu - Sayfa 5

Bilgisayar Donanımı DAQ DVI-CL01 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. DAQ DVI-CL01 17 sayfaları.

* If you do not use the DDC inside the board and provide a DVI input from the outside, remove the

EEPROM before use.

* In case of external DVI input, it is stable to give the clock within 40Mhz.

=> It is possible to input up to 160Mhz depending on the performance of the user's PC.

(1) Connect the DVI cable that receives the image to the DVI connector. For power inside the board, use

the 5V power supplied from the DVI connector when no external resources are used.다.

(2) After setting the desired resolution, connect one or two camera link cables. That is, the DVI output

is holed, It can be output by dividing it into even pixels.

(Note) The default setting is 24-bit output. (J2 connector output or CL Out(Base))

For 48-bit output, see Section 4-6, Using J4 Jumper.

(48bit output: J4 open, 24bit output: J4 short)

(3) In Base Mode, both even and odd pixels are output from the MDR26 connector. (See Table 1.)

[Table 1. One pixel per Clock Mode Data Mapping]

DATA

BLUE[7..0]

GREEN[7..0]

RED[7..0]

[Figure 2-2. DVI-CL01 Case Input Port]

[Figure 2-3. DVI-CL01 Case Output Port]

One Pixel per Clock Output

18bpp

QE[7..0]

QE[15..10]

QE[23..18]

DVI-CL01 User's Manual

26bpp

QE[7..0]

QE[15..8]

QE[23..16]