Duratuf GL75D Montaj Talimatları Kılavuzu - Sayfa 11

Dış Mekan Depolama Duratuf GL75D için çevrimiçi göz atın veya pdf Montaj Talimatları Kılavuzu indirin. Duratuf GL75D 16 sayfaları.

Sayfayı Yazdır

ASSEMBLE FRONT PANEL

SELECT:

1 x 1.980 Wall Sheets

1 x 1.980 1 Pan Wall Sheet

1 x 2.190 Top Plate (Red)

1 x 2.190 Bottom Plate (Green)

2 x 1.980 Door Jamb Flashings

16 x 30mm Galv Clouts

17 x Rivets

STEP 1:

• Lay out 1 x Top Plate and 1 x Bottom Plate on a flat surface

as shown.

STEP 2:

• Using 2 x 30mm clouts, nail the Door Jamb Flashing flush

with the top of the Top Plate at the correct measurement as

shown in plan view. Pre drill holes using a 3.5mm drill bit

• Check the distance between the top and bottom plates then

use a further 2 x 30mm clouts to nail the Door Jamb Flashings

to the bottom Plate. Pre drill holes.

STEP 3:

• Place 2x 2 Pan wall sheets on timber, ensuring wall sheets fit

underneath door jamb flashings.

• Ensure that the top of the sheet is flush with the top of the Top

Plate and that the sides of the wall sheets overhang the Top

Plate by 15mm as shown. Nail wall sheets to Top Plate (two

clouts per pan)

• Nail the wall sheets to the Bottom Plate making sure that the

Plates are the correct distance apart and that the sides of the

wall sheet overhang the Bottom Plate by 15mm.

• Drill & rivet Door Jamb Flashings to wall sheets using four riv-

ets equally spaced on each side.

STEP 4:

• Place the doors on the panel (In open position, approx 20mm

below top of top plate). Using two rivets, rivet the top and bot-

tom hinges to the Door Jamb Flashing, ensuring door closes

properly.

• Fit remaining rivets.

IMPORTANT—IF YOU CHOOSE TO RAISE YOUR TIMBER

BASE PLATE –READ THE FOLLOWING;

For sheds with Raised Base Plate option only (see page 6), deduct

30mm from measurement shown between Top and Bottom Plates on

all wall panels, so cladding protrudes 20mm below bottom plate

1948mm

15mm

TOP PLATE

BOTTOM PLATE

Plan View

TOP PLATE

DOOR OPENING

370mm

1460mm

TOP

PLATE

NAIL

DOOR

JAMB

1948mm

370mm

15mm