Duratuf KL3 Montaj Talimatları Kılavuzu - Sayfa 10

Dış Mekan Depolama Duratuf KL3 için çevrimiçi göz atın veya pdf Montaj Talimatları Kılavuzu indirin. Duratuf KL3 16 sayfaları. Kiwi series

Note:

Condensation can form on the under side of shed roof. If building paper is required, fit now. Building paper

will need to be supported by netting or roofing twine.

Roof with Clear Panel: Handle Clear Panel with care. The Clear Panel will crack if not fitted correctly.

Riveting: Pre-drill 3.5mm hole through Clear Panel and Steel. Enlarge hole in Clear Panel with drill to allow

for expansion and contraction.

Nialing: Pre-drill a 6mm hole through the Clear panel. Hammer in nails with caution.

Step 1: Check that the diagonal measurements of the shed are the same. If building on unlevel ground it may be

necessary to temporarily brace the shed with pieces of timber from the packaging.

Step 2: Position first Roof Sheet on the right

hand side of the shed with the LIP on

the left hand side. Position the next

Roof Sheet. Ensure it overlaps correctly

(when fitting a Clear Roof Panel, ensure

it OVERLAPS Roof Sheets). Rivet sheet

joins 500mm from edge, front and back.

Position and rivet remaining sheets.

Step 3: Position roof so that the front overhang

measures 140mm. Line up Ribs on the

Roof Sheets with Ribs on the Wall

Sheets. Ensure plates are straight then

nail roof to plates using one weatherseal

nail beside each Rib front and back.

KL3 ROOF

Note: KL1 shown