Duratuf PG88 Montaj Talimatları Kılavuzu - Sayfa 13

Dış Mekan Depolama Duratuf PG88 için çevrimiçi göz atın veya pdf Montaj Talimatları Kılavuzu indirin. Duratuf PG88 17 sayfaları.

Sayfayı Yazdır

ROOF ASSEMBLY

SELECT:

10 x 1.350 m Roof Sheets

2 x 2.555 m Spouting

4 x 1.352 m Barges

2 x 1.550 m Ridge Flashing

1 x 2.520 m Ridge Beam

2 x 0.200 m Jack Studs

8 x 75mm Screws

28 x 50mm Roofing Screws

62 x Rivets

36 x 50mm Clouts

STEP 1:

• Place the Ridge Beam on a level surface and use 2 x 75mm screws

to secure the Jack Studs to the underside of the Ridge Beam, one at

each end (fig. 1).

• Turn the Ridge Beam /Jack Stud assembly over and place it on the

timber Top Plate in a central position.

• Secure with 2 x 75mm screws through the top of the Jack Studs

into the Timber Top Plate (fig. 2).

• Check that the shed is sitting level and square and that the diagonal

Top Plate measurements are the same.

STEP 2:

• Position the first Roof Sheet so that the top of the sheet is at the

centre of the Ridge Beam and the side of the sheet over hangs the

end of the Ridge Beam (fig .3). Using 1 x 50mm Clout, predrill and

nail through the rib into the top corner. Repeat above and nail the

lower corner ensuring 15mm overhang.

• Position the remaining front Roof Sheets and rivet them together as

shown.

• Nail the last sheet to the Ridge Beam and the Top Plate ensuring

the Roof Sheet overhangs the end of the Ridge Beam and the Top

Plate by 15mm.

•

Nail front Roof Sheets to Ridge Beam using 1 x 50mm clout per rib.

Screw to Top Plate using 1 x Roofing screw per rib (fig.4) ensuring

Ridge Beam and Top Plate are straight.

• Repeat with remaining roof sheets.

Pan

IMPORTANT—FOR SHEDS WITH OPTIONAL CLEAR ROOF PANEL

Assemble as below, making sure that the Clear Roof Sheets overlap the stand-

ard roof sheets on both sides.

The Clear Roof Panel must be secured to the Top Plate and the Ridge Beam.

Pre drill and fasten with the 50mm roofing screws provided..

IMPORTANT

Use the 50mm Clouts only on ribs covered by flashings, shown on pg 13

Predrill holes using a 3.5mm drill bit. Use Roofing Screws on all other ribs.

Ensuring screws are not overtightened as this can damage the seals and cause

the shed to leak.

Rib

fig.4

SIDE

WALL

SIDE

WALL

RIDGE BEAM

JACK STUD

TOP PLATE

15mm

ROOF SHEET

RIDGE BEAM

JACK STUD

TOP PLATE

BACK WALL

BOTTOM PLATE

RIDGE BEAM

FRONT WALL

TOP PLATE

BACK WALL

BOTTOM PLATE

FRONT WALL

fig.2.

fig. 1

fig. 2

fig. 3

SIDE

WALL

SIDE

WALL