Duratuf SL1020 Montaj Talimatları Kılavuzu - Sayfa 11

Dış Mekan Depolama Duratuf SL1020 için çevrimiçi göz atın veya pdf Montaj Talimatları Kılavuzu indirin. Duratuf SL1020 16 sayfaları.

Sayfayı Yazdır

ASSEMBLE FRONT PANEL

SELECT:

1 x 1.020 Top Plate (Red)

1 x 1.020 Bottom Plate (Green)

2 x 1.980 Corner Door Jamb Flashing

4 x 30mm Galv Clouts

9 x Rivets

2 x Angle Braces

STEP 1:

• Lay out 1 x Top Plate and 1 x Bottom Plate

on a flat surface as shown.

STEP 2:

• Lay out angle braces at each end of Top

Plate as shown, and using four 30mm clouts,

nail to Top plate at each end.

STEP 3:

• Using 2 x 30mm clouts, nail the Door Jamb

Flashing flush with the top of the Top Plate at

the correct measurement as shown in plan

view. Pre drill holes using a 3.5mm drill bit.

• Check the distance between the top and bot-

tom plates then use a further 2 x 30mm clouts

to nail the Door Jamb Flashings to the bottom

Plate. Pre drill holes.

• Check that the frame is square and rivet angle

brace to door jamb as shown.

NOTE:

Door can be hinged on either side.

STEP 4:

• Place the door on the panel (In open position,

approx 20mm below top of top plate). Using

two rivets, rivet the top and bottom hinges to

the Door Jamb Flashing, ensuring door clos-

es properly.

• Fit remaining rivets.

IMPORTANT—IF YOU CHOOSE TO RAISE YOUR TIMBER

BASE PLATE –READ THE FOLLOWING;

For sheds with Raised Base Plate option only (see page 6), deduct

30mm from measurement shown between Top and Bottom Plates on

all wall panels, so cladding protrudes 20mm below bottom plate

1948mm

15mm

Rivet

TOP PLATE

1948mm

BOTTOM PLATE

TOP PLATE

Plan View

15mm

TOP PLATE

DOOR OPENING

960mm

NAIL

DOOR

JAMB