Duratuf Sentry SG3030 Montaj Talimatları Kılavuzu - Sayfa 15

Bahçe Evleri Duratuf Sentry SG3030 için çevrimiçi göz atın veya pdf Montaj Talimatları Kılavuzu indirin. Duratuf Sentry SG3030 16 sayfaları.

SECURING SHED

Secure your shed using Treated Timber Pegs or a Bolt Down Kit

TIMBER PEGS—WOODEN FLOOR

• The optional Duratuf Timber Peg Down Kit includes six H5 treated timber

pegs that can be hammered into the ground and then attached to the

Base Plate with stainless steel screws. A Sentry timber floor can then be

fitted on top of the Base Plate.

BOLT DOWN KIT—CONCRETE

• The optional Duratuf Bolt Down Kit includes 6 x galvanised

brackets, screws and dynabolts.

• Space the brackets evenly around the shed and fix to the Bottom

Plate and the concrete slab. A 10mm masonry drill bit is required.

OPTIONAL SENTRY FLOOR

• Position the Floor Joists centrally between the side

Base Plates and skew nail each end with two 75mm

nails.

• Check that the shed is sitting level and square and

that the diagonal Bottom Plate measurements are the

same.

• Place the Floor Boards in position. (You may need to

cut the last Floor Board to the correct width using a

Skill Saw.) Nail each Floor Board in, using two 50mm

nails each end and two nails into each floor joist.

FIT PADBOLT

• Rivet Padbolt to door and keeper onto Door Jamb as

shown.

FIT BACK PADBOLT

•

Rivet back pad bolts to pad bolt supports then rivet pad bolt sup-

ports to back of small door (Top and bottom)

•

Using 10mm drill bit, drill hole into top and bottom timber plates

IMPORTANT— CLEAN UP

REMOVE ALL DRILL FILINGS FROM ROOF, WALLS AND CHANNELS

THOROUGHLY. FAILURE TO DO THIS WILL RESULT IN CORROSION

AND COULD THEREFORE VOID THE WARRANTY

YOUR DURATUF SENTRY SHED IS NOW COMPLETE. RELAX......

BACK BASE PLATE

JOIST

FRONT BASE PLATE