DURAVAC CVWM510 Operatör El Kitabı - Sayfa 8

Elektrikli Süpürge DURAVAC CVWM510 için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. DURAVAC CVWM510 14 sayfaları. Wet/dry vacuums

DRY-VACUUM OPERATION

DRY VACUUMING

WARNING:

BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION, ENTITLED

'SAFETY INSTRUCTIONS & WARNINGS'. DO NOT VACUUM IN AREAS WITH FLAMMABLE GASES,

VAPORS, OR EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE GASES OR VAPORS INCLUDE BUT

ARE NOT LIMITED TO; LIGHTER FLUID, SOLVENT TYPE CLEANERS, OIL-BASE PAINTS, GASOLINE,

ALCOHOL OR AEROSOL SPRAYS. EXPLOSIVE DUSTS INCLUDE BUT ARE NOT LIMITED TO;

COAL, MAGNESIUM, GRAIN OR GUN POWDER. TO REDUCE THE RISK OF HEALTH HAZARDS

FROM VAPORS OR DUST, DO NOT VACUUM TOXIC MATERIALS.

1. Verify that the power cord is disconnected from the outlet. (fig. 1)

2. In order to prepare your vacuum for dry vacuuming, verify that the cartridge filter is securely mounted.

Make sure the filter is pushed in until it stops against the power head. (fig. 2) (Your Wet/Dry Vac comes

with the cartridge filter pre-installed, if not see page 11 for installation instructions.)

3. Place filter retainer on top of cartridge filter and tighten down by turning the retainer handle clockwise.

(fig. 3)

4. Place the power head back on the container, aligning the top section with the latches, and snap into

place. (fig. 4)

OPERATING INSTRUCTIONS: DRY VACUUMING

5. Insert the locking end of the hose onto the vacuum port on the power head and lock in place. Push the

required attachment onto the free end of the hose or extension. (fig. 5)

6. Plug the power cord into the outlet and hang the vacuum onto the rack or use off the rack . (fig. 6)

7. Turn the motor on by flipping the switch to the 'I' ON position. (fig. 7) For remote control use, set the

power switch to remote control position "

button on the remote control handle for at least one second. (fig. 8 & 9)

8. Once you have completed vacuuming, flip the switch to the 'O' OFF position or press the 'O' OFF button

on the remote control for at least one second.

O = OFF

DO NOT USE THE CARTRIDGE FILTER FOR LIQUID VACUUMING.

I = ON

" and turn the vacuum on by pressing the 'I' ON

= Remote Control