DURAVAC PRO31M Kullanıcı Kılavuzu - Sayfa 12

Elektrikli Süpürge DURAVAC PRO31M için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. DURAVAC PRO31M 17 sayfaları.

NOTHING IS TOUGHER

7. TROUBLE SHOOTING

Repair or service of electrical components such as cord or motor, must only be carried out by an

authorized service center.

Vacuum does not start:

Motor does not run in

automatic mode

Motor stops:

Suction power is reduced:

Static shocks:

12.

• Check to see that the plug is correctly inserted in the electrical outlet

and that there is power at receptacle.

• A circuit breaker may have tripped. Check the circuit breaker box.

• The cord or plug may be damaged. Call the Customer Service

Department to get the nearest authorized service center.

• Power tool defective or not connected properly. Check that the power

tool works or that the plug is inserted correctly.

• The power rating of the electrical tool is too low. Note that minimum

power rating is P>50W

• A thermal overload protector will shut oﬀ the motor if the motor

temperature is too high. If this occurs, turn the switch oﬀ. Wait 10

minutes for the motor to cool. Turn switch on and resume operation.

• The tank may be full and needs to be emptied. See chapter 4.7 and 4.8.

• The wands, hose and nozzle may be clogged and need to be cleaned.

• Any of the above may be damaged and need to be replaced.

• The ﬁlter may be clogged. Use the Filter Cleaning System

(see chapter 5), to clean the ﬁlter.

• Check the ﬁlter and replace it, if it's necessary. Make sure that is

installed properly.

• The hose connection is loose and need to be tightened.

• If the environment is too dry, add moisture to air. If possible, use a

humidiﬁer.

• In case the relative humidity of air is low, please note that this situation

will not have any eﬀect on use of the vacuum cleaner.

PRO30L & PRO31M