DuraVent FasNSeal W2 Kurulum Talimatları Kılavuzu - Sayfa 6

Havalandırma Davlumbazı DuraVent FasNSeal W2 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. DuraVent FasNSeal W2 12 sayfaları. Double-wall vent for category ii, ii, iv appliances

Sayfayı Yazdır

Correct Joint Connection.

Male/Female sections fully engaged.

INCORRECT Joint Connection.

Male/Female sections NOT fully engaged.

the female end (2) measures 2", leaving 12" to

telescope into a standard vent length.

the W2-aVL must penetrate no less than 4" into

a standard vent length (3) to assure a good seal

and structural stability.

this leaves up to 12" in true axial adjustability (4).

JOINT CONNECTIONS

the female end of each FasNSeal W2

component incorporates a sealing gasket. the

mechanical locking band is built into the outer

tube of FasNSeal W2 male end. examine all

components prior to installation. Gaskets must

be in proper position or flue gases could leak

and result in carbon monoxide poisoning.

1. Insert the male end into the female section.

Push the units together and turn them until

the bead of the male end is seated against

the flared end of the female section (see

photo to the right). From within the tube,

the sealing gasket must not be visible. this

creates the needed airtight seal for Category

II, III or IV appliances. align the seams on the

vent lengths and orient them upward in all

horizontal applications.

2. tighten the locking band with a nut driver

until snug plus 1/4 turn.

Before proceeding, recheck all joints and

ensure that all male sections extend to the

top of the flared female end and all clamps

are tightened.

Stop bead on male end must be pushed

directly against the flared end of the female

end. When checking the inside of the joint, the

gasket is fully covered and out of sight.

APPLIANCE CONNECTION

Connect FasNSeal W2 to the appliance

flue collar as directed in the appliance

manufacturer's instructions. If the appliance

flue collar is not designed to accept FasNSeal

W2 directly, an adapter may be available.

Some appliance adapters may require a

Single-wall to Double-wall transition adapter.