4B Touchswitch Kullanım Kılavuzu - Sayfa 9

Aksesuarlar 4B Touchswitch için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. 4B Touchswitch 20 sayfaları. Belt misalignment sensor

• Touchswitch™ wiring is low voltage DC.

• Use shielded cable and keep separate from high voltage cable.

• Never run Touchswitch™ cables in the same conduit as 3-phase motor cables.

• Track belts and commission plant prior to installing Touchswitches.

• Fabricated brackets must be built rigid enough to take pressure from a misaligned belt.

Install Touchswitches on machinery only after they have been wired to a power source, and can

alarm / shutdown the equipment being monitored.

All wiring must be in accordance with local and national electrical codes and should be undertaken by an

experienced and qualified electrician.

If required by local installation code, use dust/liquid tight flexible metal conduit with approved fittings to

protect the sensor cables. Conduit systems can channel water due to ingress and condensation directly

to sensors and sensor connections which over time will adversely affect the performance of the system.

As such, the installation of low point conduit drains is recommended for all sensors.

Mount a suitable junction box within 3m (9 ft.) of the sensor, and using a suitable conduit to protect the

cables, make the necessary wiring connections inside this junction box. A 3 meter, PVC coated cable

connected to the sensor contains the following 22 AWG wires:

RED -

BLACK -

GREEN -

WHITE -

BLUE -

ORANGE -

WARNING

NOTE

STANDARD WIRING

12-24 VDC

0 VDC

Ground

Solid State Relay Common

Solid State Relay Normally Open (Sensor Output)

Not connected

PAGE 9