Aplisens APM-2 Cihaz Kılavuzu - Sayfa 5

Verici Aplisens APM-2 için çevrimiçi göz atın veya pdf Cihaz Kılavuzu indirin. Aplisens APM-2 17 sayfaları. Smart electronic differential pressure transmitters

Sayfayı Yazdır

INTRODUCTION

This manual is only applicable to the APM-2 series transmitters in Ex (explosion-proof), Exi

(intrinsically safe), Exd and Ext (flameproof). The transmitters are identified with model ID on

nameplates and also as specified in section 4. Ex information are included in the "Product

Certificate". Model ID indicates type and version of transmitter. The manual contains most

important information on intrinsically safe and flameproof transmitters compliant with ATEX

directive. If explosion-proof transmitters are installed, refer to this manual and also:

User's manual EN.IO.APM.2.

SAFETY

−

The installation and start-up of the device and any activities related to operation

shall be carried out after thorough examination of the contents of user's manual

and the instructions related thereto.

−

Installation and maintenance should be carried out by qualified staff having the

required authorizations to install electrical and measuring devices.

−

The device shall be used according to its intended purpose in line with the

permissible parameters.

−

Before installing or disassembling the device, it is absolutely necessary to

disconnect it from the power source.

−

No repairs or alterations to the transmitter electronic system are permitted.

Assessment of damages and possible repair may only be performed by the

manufacturer or authorized representative.

−

Do not use instruments if damaged. In case of malfunction, the device must be

put out of operation.

−

If the equipment is used in Ex zones, the technical requirements specified in this

manual and applicable local (national) regulations must be followed.

Revision 01.A.001/2022.09

EN.IX.APM.2