APlusLift HW-10KOH Kurulum Kılavuzu ve Çalıştırma Talimatları - Sayfa 10
Kaldırma Sistemleri APlusLift HW-10KOH için çevrimiçi göz atın veya pdf Kurulum Kılavuzu ve Çalıştırma Talimatları indirin. APlusLift HW-10KOH 17 sayfaları. 2-post over head car lift 10,000lb capacity
Ayrıca APlusLift HW-10KOH için: Kurulum ve Kullanım Kılavuzu (20 sayfalar)
Sayfayı Yazdır
hose cross the overhead beam. Run the hose down to the side of opposite column. Connect long hydraulic hose to 4.3 inches
extended fitting in bottom of cylinder. DO NOT over tighten, as you will crack the fitting. Connect long hydraulic hose
between the cylinders and let it lay inside the floor pan. See figure 5 for hose layout and routing to the power unit.
You could find one Tee fitting and two extended fitting in the bag of fasteners.
INSTALLING SWING ARMS
•
Locate the 4 swing arms and swing arm pins. Take one of the arms and insert it over the hole in the carriage torsion
tube. Line up the holes and insert the pin. Repeat for the three other arms.
ELECTRICAL CONNECTION
HAVE A QUALIFIED ELECTRICIAN HOOK THE MAIN ELECTRICAL POWER CONNECTION TO THE
POWER UINT ON THE LIFT. FOLLOW LOCAL CODES IN YOUR AREA.
•
The electricity is to be hooked up at the power unit. This is 220 volt single phase power unit. There is one cluster with three
wires out of motor. Yellow/Green is ground wire. Blue is neutral wire. Brown is live wire. The power supply to the lift
should be 220 Volt with a 30 amp breaker.
•
wire length less than 10mm, wire size is 2.5MM2 / wire length more than 10mm wire size is 4MM2
Figure 5.
10