APlusLift HW-10KBP-A Kurulum ve Kullanım Kılavuzu - Sayfa 3
Kaldırma kolonları APlusLift HW-10KBP-A için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. APlusLift HW-10KBP-A 20 sayfaları. 2-post floor plate car lift 10,000lb capacity
Sayfayı Yazdır
READ THIS BEFORE INSTALLING THE LIFT! Improper installation can cause injury or
damage!
Read this installation and operation manual in its entirety before attempting to install
the lift. Manufacturer or distributor assumes no responsibility for loss or damage of any
kind, expressed or implied, resulting from improper installation or use of this lift. Always
use professional installation companies.
All persons using the equipment must be responsible, qualified, and carefully follow the
operation and safety guidelines contained in this manual.
A level floor is required for proper lift installation and operation.
DO NOT install this lift on any asphalt surface. Recommend on concrete surface a
minimum of 6" thick and 3,500 psi tensile strength with steel or fiber mesh
reinforcement. If you always lift vehicles below 9,000LB, 4" thick concrete will be fine.
DO NOT install this lift over concrete expansion joints or cracks. (Check with your
building architect)
DO NOT install this lift on an upper floor without written authorization from your
building architect. Should only be installed on a ground floor without a basement.
DO NOT attempt to lift only part of a vehicle. This lift is intended to raise the entire
body of a vehicle only. This will bend the arms and void the warranty.
NEVER lift any persons or vehicles containing persons. This lift is designed to lift
empty vehicles only.
Concrete rotary hammer drill with 3/4" drill bit
Rubber hammer
Chalk line
Sockets and open wrench set
Ratchet driver
Vise grips
Tape measure
Screwdrivers
Torque wrench
Two 10' to 12' step ladders
4' level
12" crescent wrench
AW32 non-foaming hydraulic fluid (4 gallons)
Important Information
Preparation
3