Apogee X-Digi-Mix Card Kullanıcı Kılavuzu - Sayfa 5

Bilgisayar Donanımı Apogee X-Digi-Mix Card için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Apogee X-Digi-Mix Card 12 sayfaları. X series

Installing the X-Digi-Mix Card

Plastic standoff here

Your X-Digi-Mix card should include the following:

• 1 X-Digi-Mix circuit board

• 1 X-Digi-Mix Coverplate

• 2 aluminium standoffs,

• 1 plastic standoff

• 1 user's guide

The procedure for installing the X-Digi-Mix card into an Apogee

Rosetta 800 is shown below:

1) Remove the top cover of the interface

2) Remove the Option Card coverplate and install the

X-Digi-Mix coverplate using the screws from the original

coverplate.

3) Remove the two interface circuit board screws as

indicated to the left, and set them aside for later use.

4) Install the two aluminium standoffs in the holes vacated

by the screws.

5) Install one end of the plastic standoff in the hole adjacent

to the connector pins of the X-Digi-Mix card: install the

other end in the hole adjacent to the mating connector.

6) Insert the BNC/Peripheral connector end of the X-

Digi-Mix card through the appropriate cutouts in the

coverplate, and carefully place the X-Digi-Mix connector

pins in the mating interface connector.

7) After verifying the alignment of the X-Digi-Mix connector

pins and the interface mating connector, firmly press

down on the X-Digi-Mix card, over the connector, until

the pins are completely seated in the mating connector.

8) Re-install the circuit board screws in the locations

indicated below.

X-Digi-Mix – User's Guide

APOGEE ELECTRONICS