4D systems GEN4-4DCAPE-70CT-CLB Başlangıç Kılavuzu - Sayfa 7
Kontrol Ünitesi 4D systems GEN4-4DCAPE-70CT-CLB için çevrimiçi göz atın veya pdf Başlangıç Kılavuzu indirin. 4D systems GEN4-4DCAPE-70CT-CLB 14 sayfaları. Lcd cape for beaglbone black
7. Once power is connected, something should be displayed on the gen4-
4DCAPE a few moments after it has started to boot. Each distribution
will behave differently and might require different input from the User
(It is recommended to have a keyboard attached while setting the
system up, as login details etc. may be required). Some distributions may
prompt for LCD calibration during the first boot, while others may
prompt for Username/Password.
gen4-4DCAPE Troubleshooting
For older versions of the BeagleBone Boards, the eMMCs of these boards
might have an outdated version of the U-boot which will not load with the
gen4-4DCAPE properly.
To know the bootloader version and if it is applicable to be used with the
gen4-4DCAPE, run the following code:
$ sudo /opt/scripts/tools/version.sh | grep bootloader
Check the versions of "microSD" and "eMMC". To work properly, the
"microSD" version must be older than the "eMMC" version and it must be
greater than 2018.03.
To fix this, remove the version of U-boot from the eMMC. An example is
clearing the 10Mb of the drive:
$ sudo dd if=/dev/zero of=/dev/mmcblk1 bs=1M count=10
gen4-4DCAPE-XXT/CT-CLB - GETTING STARTED MANUAL
|
7