APOGEE ACOUSTICS ORIGINAL ACTIVE CROSSOVER Kullanım Kılavuzu ve Kurulum Talimatları - Sayfa 7
Çapraz Geçiş APOGEE ACOUSTICS ORIGINAL ACTIVE CROSSOVER için çevrimiçi göz atın veya pdf Kullanım Kılavuzu ve Kurulum Talimatları indirin. APOGEE ACOUSTICS ORIGINAL ACTIVE CROSSOVER 9 sayfaları.
Sayfayı YazdırSPEAKER CONNECTIONS FOR BI-AMP
1. Connect the woofer cables to the woofer binding posts of the transformer box.
Blue cable to blue binding post and black cable to black binding post.
2. Connect midrange cables to the midrange binding posts. White cable to white
binding post and black cable to black binding post.
3. Connect the tweeter cables to the tweeter binding posts. Red cable to red
post and black cable to black post.
SCINTILLA BI-AMP OPERATION WITH AN ACTIVE CROSSOVER NETWORK
The Scintilla may be operated in a bi-amped mode utilising an active crossover
network in the signal path between the pre-amplifier output and the power amplifier
input. The internal speaker wiring is shown in the binding post table. The system
wiring is shown in Figure 3.
The internal speaker wiring, for use with the signal level crossover network,
removes the speakers internal woofer and midrange power crossover networks. This
configuration consequently provides a resistive speaker load to the amplifier in
the bass and midrange/tweeter audio regions and subsequently improved amplifier
performance and headroom.
The woofer crossover is at 305 hertz with a
midrange/tweeter crossover is at 700 hertz with a positive slope of 6 dB per
octave.
BINDING POST
Red --------------------------------- Green with Black Shrink
Black ------------------------------- Black
White ------------------------------- Blue
Blue -------------------------------- Grey, Orange
Note:
Speaker wire lugs that are not terminated at the binding posts should
be covered with the enclosed plastic tubing. Be certain that the lug is
properly covered and that it will not short out. If the plastic tubing
is not available, use electrical tape to cover the lugs that are not
terminated at the binding posts.
SCINTILLA BINDING POST WIRING
BI-AMP OPERATION WITH ACTIVE CROSSOVER
6 dB per octave slope. The
SPEAKER WIRE
(Page 6)
_______