Apogee Instruments ST-110 Kullanıcı El Kitabı - Sayfa 16

Sıcaklık Kontrolörü Apogee Instruments ST-110 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Apogee Instruments ST-110 18 sayfaları.

Modifying Cable Length

When the sensor is connected to a measurement device with high input impedance, sensor output signals are not

changed by splicing on additional cable in the field. Tests have shown that if the input impedance of the

measurements device is 1 mega-ohm or higher then there is negligible effect on ST series temperature sensors,

even after adding up to 100 m of cable. See Apogee webpage for details on how to extend sensor cable length

(http://www.apogeeinstruments.com/how-to-make-a-weatherproof-cable-splice/). For cable extensions, shielded,

twisted pair cable is recommended, in order to minimize electromagnetic interference. This is particularly

important for long lead lengths in electromagnetically noisy environments.

The precision bridge resistor is located at the pigtail end of the ST-300 cable. Thus, the ST-300 temperature sensor

cables should not be shortened, otherwise the bridge resistor will be removed.