Apollo 51000-600 Kurulum Kılavuzu - Sayfa 8

Duman Alarmı Apollo 51000-600 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Apollo 51000-600 15 sayfaları. Wireless combination smoke, heat and carbon monoxide detector

Sayfayı Yazdır

7.2 RECOMMENDED LOCATIONS FOR CARBON MONOXIDE DETECTORS

Ceiling Mounted - position at least 12" from any wall.

Wall Mounted - position at least 6" from ceiling, but not lower than a light switch.

Where to install, ideally:

• Within 10 feet (3m) of a sleeping area

• Inside the bedroom if it contains a fuel burning appliance

• On every floor of the building

• Ideally, install in any room that contains a fuel burning appliance

• If the appliance or the room is not normally used, such as the boiler room, the

detector should be placed just outside the room so the alarm can be heard

more easily

Figure 12 - CO Detector location diagram

Where NOT to install, ideally:

• Directly above a sink, cooker, stove or oven

• Do not locate detector within 5 feet (1.5m) of any cooking appliance

• Next to a door or window that would be affected by drafts i.e. extractor fan or

air vent

• Outside

• Do not install in any environment that does not comply with the detector's

environmental specifications

• In or below a cupboard

• Where air flow would be obstructed by curtains or furniture

• Where dirt or dust could collect and block the sensor

• Where it could be knocked, damaged, or inadvertently removed

7.3 MOUNTING PROCEDURE

NOTE: The Wireless Combination Smoke, Heat and Carbon Monoxide Detector

should only be installed by a competent technician or installer.

NOTE: The Wireless Combination Smoke, Heat and Carbon Monoxide Detector

must not be used with a guard.

NOTE: DO NOT attach the detector to removable ceiling panels.

NOTE: Two warning labels are provided with the detector. One should be mounted

near the CO detector and the other near a source of fresh air where members of the

household will gather if the alarm signal sounds.

CAUTION: Airborne dust particles can enter the detector, remove the detector

before beginning construction work or other dust producing activity. Immediately

replace detector when dust producing activity has ceased.

WARNING: DO NOT PAINT Detector

Once a suitable location has been identified install the mounting base on the ceiling

or wall (if local ordinances permit) using the two screws and anchors provided

(Figure 13). Remove the battery pull tab (Section 5.1) and ensure the detector

powers up (Section 5.2). Fit the detector on the mounting base (Figure 14) and

turn clockwise until the detector clicks into place and the alignment notches are

aligned (Figure 15). Test the detector as described in Section 9 FIELD SERVICE

TESTS of this installation guide.