4DRC 4D-M1 Kullanım Talimatları Kılavuzu - Sayfa 7

Quadcopterler 4DRC 4D-M1 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. 4DRC 4D-M1 12 sayfaları.

12.3 Turn on the remote control (default mode)-press the

power switch button

1) and turn on the remote control, the power

indicator will flash. The throttle lever is pushed up to

the top (step 2) and then to the bottom (step 3), the

code matching will complete and the indicator of the

remote control will be always on.

12.4 Horizontal calibration operation:

Push the left and right joysticks on the remote control to the lower right corner at the same time, and the lights

on the aircraft will flash quickly. When the lights on the aircraft flash slowly, it means the calibration is

complete, when the remote control will emit a sound of beep (Figure 1).

APP operation: Click the "Set more" icon in the APP interface, and operate following the text prompt after

entering, and it can also be horizontally calibrated. When the APP indicates that the

calibration is complete, it will automatically proceed to the next step (Figure 2).

Note: The calibration must be completed only when the aircraft is placed on a horizontal plane.

12.5 Geomagnetic calibration operation

1. Short press the

geomagnetic

calibration button

until the light on the

aircraft flashes quickly.

APP operation: In the interface of "Set more", according to the text prompt and operation steps, the guide

calibration can also be done (Figure 4). When the APP prompts that the guide calibration is

complete, it will automatically enter the start to fly interface.

of the remote control (step

Figure 1

Figure 2

Figure 3

2. Horizontal clockwise rotation -

Pick up the aircraft horizontally

and rotate clockwise until the

device emits a sound of "beep",

and the horizontal calibration is

completed.

Figure 4

3. Rotate the aircraft clockwise with the

tail upwards: pick up the aircraft with

the nose being vertically downwards

and rotate clockwise until the remote

control emits a sound of "beep" when

the light flashes slowly, which means

the guide calibration is completed.