AddSecure IRIS-4 2 Series Hızlı Kurulum ve Bakım Kılavuzu - Sayfa 7

Güvenlik Sistemi AddSecure IRIS-4 2 Series için çevrimiçi göz atın veya pdf Hızlı Kurulum ve Bakım Kılavuzu indirin. AddSecure IRIS-4 2 Series 9 sayfaları.

Sayfayı Yazdır

IRIS-4

2 Series

Quick Installation and

Maintenance Guide

To investigate any faults or to perform checks, the

IRIS-4 2 Series dialler gives engineers the option via

the touch screen, to see the current faults, reflash to

latest software and perform communication path

checks . Engineers will need to touch the screen

to exit the screen saver mode and should now be

presented with the welcome screen . Engineers will

now see the option indicating status and the option

to enter the installer menu . The engineer will now be

able to perform the following checks:

7.1. Confirm Current Status

The IRIS-4 2 Series dialler will indicate "Status – ok"

if the current dialler setup is all working correctly,

and if the status is showing "Status – Trouble" the

dialler has a trouble reported . To view the reported

trouble click on the "Status – Trouble" option then

"View Trouble Report" .

Check the reported system troubles via the "Trouble

report" menu . Please refer to the IRIS-4 2 Series

Series Engineering Manual for more details available

from http://www . a ddsecure . c om .

7.2. Check Software Version/Reflash

Enter the 'Installer Menu', which will prompt for

the installer code, check installation documentation

to see what this is set to . Once in go to the settings

menu and then scroll down and select the 'Reflash'

option . On first entry to the reflash option, which

could be during installation or maintenance, the

engineer will be required to change the password as

required for EN50136-2 compliance . Please record the

password on the installation documentation .

Enter the correct reflash password and you will then

have the following options .

The AddSecure Reflash server IP address will already

be setup under the 'Reflash IP Address' but if using

an alternative Reflash IP address then change the IP

address . Once you have the correct reflash IP address

entered press the 'Reflash Now' to connect to the

server and check if there is a later version, and if there

is, it will start to reflash .

The reflash will take up to 15 minutes if via 2/3/4G

and approximately 2 minutes with the Ethernet

connection . Once completed the dialler will reboot

and switch to the new software .

Note: All configurations for the IRIS-4 2 Series

dialler are stored and there is no need to reconfigure.

During the reflash process, do not remove power

until dialler has completed and reset.

7.3. Communication Paths Checks

The engineers can test the communication paths

for both polling and alarm communications using

the 'Test' option in the Main Menu . This will

perform communication path checks for each path

configured .

Please refer to the IRIS-4 2 Series Engineering

Manual for more details available from

http://www . a ddsecure . c om .

7.4. test alarm Panel alarms and

Communication to Monitoring Centre

Depending on the Monitoring Centre engineers will

now be required to perform alarm test and possibly

other tests to the Monitoring Centre . Before the engi-

neer leaves site get confirmation from the Monitoring

Centre that all is working correctly .

7.5. touch Screen Calibration

The IRIS-4 2 Series dialler allows Engineers to recal-

ibrate the touch screen if required . To perform this

you have two options as detailed below:

• On initial power on: 'Touch Calibration' box in

the top part of the screen for a few seconds .

• In the Installer Menu > Settings > Display >

Touch Calibration .

Press the 'Touch Calibration' box and follow the

on screen prompts to calibrate the screen, as shown

below: