Appareo STRATUS ESG Manuel - Sayfa 9

Alıcı Appareo STRATUS ESG için çevrimiçi göz atın veya pdf Manuel indirin. Appareo STRATUS ESG 9 sayfaları. Portable receiver connector plate
Ayrıca Appareo STRATUS ESG için: Pilot El Kitabı (13 sayfalar), Kurulum Kılavuzu (5 sayfalar)

Sayfayı Yazdır
Appareo STRATUS ESG Manuel
4. Press the right arrow key.
5. Press the left arrow key to return to the registration screen. Confirm
that it now reads "ACK."
6. Re-enter your aircraft's registration information, and confirm that all
other configuration settings are correct.
7. Verify that GPS satellites can acquire in a timely manner.
Are the BIT codes for Stratus ES and Stratus ESG different?
Yes, some BIT codes are only for Stratus ES, and some are only for Stratus
ESG. There are also differences in BIT codes between software version R06
and R07. Refer to the Stratus ES & ESG Installation Instructions for BIT codes.
Why is my Garmin 430W/530W not working as a GPS
position source?
If you're using a Garmin 430W/530W as a GPS position source, it requires
main SW version 5.02 or higher. GPS SW must be 5.0 or higher
Connect Stratus ES to an open RS232 serial port (out) on the GPS position
source and use the GPS position source to configure the port to use the
ADSB+ protocol.
I have BIT Codes triggered, how do I clear/reset these BIT
codes?
Press the 'enter' button when on the BIT code page to clear/reset any
triggered codes.