DURHAND B72-037 Talimat Kullanımı - Sayfa 7

Masaüstü DURHAND B72-037 için çevrimiçi göz atın veya pdf Talimat Kullanımı indirin. DURHAND B72-037 15 sayfaları. Five-in-one workbench household & diy workstation

Sayfayı Yazdır

1. Set up the legs by following the same steps as the scaffold mode.

2.Pull up the switch on the side of each leg to release them, then pull the inner

legs out to the workbench height - 66cm or 80cm. There are three locking posi-

tions -the lowest is scaffold mode which is 52cm, the second is 66cm and the

highest is 80cm. Gently turn the workbench upright onto a stable, level surface.

Vice Pegs

3.Please follow the below steps to connect with a quick clamp.

1)Remove the small plastic part of your quick clamp (Fig 1).

2)Put the steel bar into the connector (Fig 2) and push the pin into the lock hole,

make sure they are connected firmly (Fig 3).

3)Put the connector into the Sawhorse hole on the workbench surface and

rotate at least 30 degrees (Fig 4).

4) With the help of the two vice pegs on the workbench, the sawhorse is com-

plete.

NOTE: DO NOT step on the workbench while the legs are extended.

MAINTENANCE

● It is recommended that the general condition of any workbench be examined

before use. Keep your workbench in good condition by regularly checking the

product. Have necessary repairs made by qualified service personnel.

● Clean the workbench on a regular basis.

-7-