APPENDIX SCE 2000 Manuel - Sayfa 4

Kontrol Ünitesi APPENDIX SCE 2000 için çevrimiçi göz atın veya pdf Manuel indirin. APPENDIX SCE 2000 8 sayfaları. External optical bypass module

Sayfayı Yazdır

Installing the External Bypass Module

Figure A-3
Installing the External Bypass Module
Installation of the External Optical Bypass module requires two main steps, which are described in detail
in the following sections.
•
•
How to Install the Module in a Rack
The following procedure describes how to install the module in a 19" rack.
Note that, although each module is shipped with its own mounting panel, it is not necessary to install
each module in a separate mounting panel. Up to three modules may be installed in one mounting panel.
Step 1
Using the screws attached to the module, screw it into an empty position in the mounting panel.
Step 2
Secure the module panel to the two front posts of the rack above the SCE 2000 platform. Leave at least
1.5 cm vertical clearance between the SCE 2000 platform and the module panel to provide space for the
cables from the front panel of the module to the rear of the SCE 2000 platform.
Cisco SCE 2000 4xGBE Installation and Configuration Guide
A-4
External Optical Bypass Module
1
2
Sub
Tx
Rx
How to Install the Module in a Rack, page A-4
How to Cable the External Optical Bypass Module, page A-5
Appendix A
1
3
2
Net
Control
Tx
Rx
The External Optical Bypass Module
No Bypass
4
5
OL-21096-02