AddSecure IRIS-4 50 Hızlı Kurulum ve Bakım Kılavuzu - Sayfa 3

Dokunmatik terminaller AddSecure IRIS-4 50 için çevrimiçi göz atın veya pdf Hızlı Kurulum ve Bakım Kılavuzu indirin. AddSecure IRIS-4 50 8 sayfaları.

Sayfayı Yazdır

3. PRODUCT FEATURES

FEATURES
Cellular network interface 2/3/4G
eSIM
Dial capture input
Pin inputs
Relay outputs
Serial input (RS232)

4. BEFORE YOU START

The terminal must have its cellular subscription activated, prior to installation, by going
to www.addsecure.com/activate, and using the Terminal Activation Code (TAC), which is
found on the terminal and the packaging. Make sure that the monitoring centre (ARC) to
which the terminal will send alarm signals is equipped with the appropriate IRIS Secure
Apps receiving system.
The following information should be obtained from the Monitoring Centre.
• Terminal account number.
• Monitoring centre IP address.

5. LED INDICATIONS

LED COLOUR
Terminal status (green)
Cellular (yellow)
Panel (red)
All LEDs
DISPLAY
On, steady
Flashing, on 0.5s, off 0.5s
On
Flashing, 0.5s on. 0.5s off
Flashing, 0.1s on, 0.9s off
Off
On
Flashing, on 0.5s, off 0.5s
Will flash together for a short period when the terminal has been defaulted.
Will blink together for a short period if the terminal is installing new
software which it has received.
IRIS-4 50
1
1
1
2
2
1
REASON
No faults.
One or more fault present.
Cellular OK, will flicker off for 0.1s to
shows poll to alarm receiver at ARC.
Polling failed or not configured.
Registered to cellular network, but
no IP connection.
Not registered to cellular network.
Panel interface OK.
Panel interface fault, either Dial Capture
tamper, pin input tamper or no serial
activity. Note each of these fault notifica-
tions are disabled by default.
3