Appion G1 Single Kullanım Kılavuzu - Sayfa 14

Test Ekipmanları Appion G1 Single için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Appion G1 Single 20 sayfaları. Single cylinder

Care and Maintenance

INLINE FILTER DRYERS

Use a new inline filter dryer on the input side of the G1Single when pumping dirty refrigerant. Refrigerant

acts like a solvent and can collect dirt and debris when it is pumped out of a system. Failure to use an

inline filter dryer can cause damage to the compressor, and will void the warranty on your machine.

While specifications may vary, most Size 032 filters will not be effective for more than 50 lbs. (22.6 Kg)

of refrigerant. Also, once refrigerant has been introduced into the inline filter, it may continue to wear

down, and may not have the same effective capacity if used across multiple jobs. Change the inline

filter dryer regularly, and consult the filter manufacturer for expected capacity.

SCREEN CLEANING AND REPLACEMENT

The G1Single is equipped with a debris screen inside the input fitting. This is the last line of defense

for the recovery machine against any debris that might make it past an inline filter. For best results it is

recommended to clean it before each use. If it becomes worn, replace it immediately.

1. Unscrew Filter Cap from Input Port.

2. Remove screen from Filter Cap.

3. Clean screen and Filter Cap thoroughly. If the

screen is worn or damaged, replace it.

4. Check the O-ring that seals the Filter Cap

to the Input Port. If it is dry, apply a drop of

refrigeration oil. If it is damaged, replace it.

5. Place clean screen into Filter Cap and screw

it back onto the Input port.

PLANNED MAINTENANCE

You can use any standard refrigeration oil (mineral is ideal) to scavenge out dirt and debris, and

recondition the seals. Run the machine with no hoses connected. Using a 1/4" port cap, fill it with

refrigeration oil and hold it up against the input port, allowing the G1Single to suck it in. Place a towel

below the output port to catch any oil spray. This is very helpful after recovery of burnout systems, and

as regular maintenance depending on the frequency of use.

G1SINGLE OPERATION MANUAL

Diagram 9