Data Harvest 1101 Manuel - Sayfa 10
Sıcaklık Kontrolörü Data Harvest 1101 için çevrimiçi göz atın veya pdf Manuel indirin. Data Harvest 1101 18 sayfaları. Wireless fast response temperature sensor
Sayfayı YazdırUsage Information
·
Temperatures higher than 125 ̊ C (257 ̊ F ) or lower than -40 ̊ C (-22 ̊ F ) will damage the sensor.
·
This Temperature sensor is NOT recommended for use with laboratory chemicals.
·
Do NOT put any part of the sensor into a direct flame or onto a hot plate.
·
The total length of PVC cable and thermistor wire is approximately 39 cm. It is made up of about 17
cm of PVC cable, approx. 3.5 mm diameter, with approx. 4 cm of heat shrink tubing linking the
cable to the thermistor wire. The length of thermistor wire and bead is approx. 18 cm long, with a
diameter of approx. 2 mm.
·
The electronics in the Smart Wireless module of the sensor have a working range of 0 to 40 ̊ C .
Position the sensor so that this part of the sensor is kept away from the source of heat. Take steps
to protect against excessive steam.
·
The Smart Wireless module is not waterproof; it has an operating range of 0 to 95% RH (non-
condensing). Do not place the sensor in an environment in which high humidity levels are possible,
as this may result in damage or malfunction.
·
Do not submerge the sensor. Clean the Smart Wireless module using a damp cloth; do not
immerse in water or detergent.
·
If the sensor has been left in the cold, let it warm to near room temperature before waking it from
sleep.
1101 - Wireless Fast Response Temperature Sensor
10 / 18 | Revision: 3.0 | DS168