Applanix APX-18 Donanım Entegrasyon Kılavuzu - Sayfa 14

Alıcı Applanix APX-18 için çevrimiçi göz atın veya pdf Donanım Entegrasyon Kılavuzu indirin. Applanix APX-18 15 sayfaları.

8. Mounting

The APX-18 is mounted using six holes with 3mm screws. In order to measure the

orientation of a sensor using APX-18 to the specified accuracy level, the following

guidelines must be followed:

 The board must be rigidly mounted directly to the device being measured such

that there is no relative motion (translation or rotation) between the board and the

device

 Special care must be taken when mounting the board so that force distribution

across the mounting points is equal and there is no possibility of warping the

board

 The sensor with the attached board (ie the payload) must be isolated from any

significant high-frequency vibration (> 5 Hz) through the use of damping isolators

or shock mounts. Failure to do so will result in reduced orientation accuracy

measurement.

 The APX-18 does not support use on a Gimballed platform where the GNSS

antennas are mounted fixed to the vehicle frame.

The optional accessories for APX-18 board are:

 Development board kit

They are not included in default shipment.

OR BY ANY MEANS WITHOUT THE PRIOR WRITTEN CONSENT OF APPLANIX CORPORATION.