AddSecure Edge VS5051 Kullanıcı Kılavuzu - Sayfa 8
İnterkom sistemi AddSecure Edge VS5051 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AddSecure Edge VS5051 14 sayfaları. Connect intercom
Ayrıca AddSecure Edge VS5051 için: Kullanıcı Kılavuzu (10 sayfalar)
Sayfayı Yazdır
7.8 Powering up the terminal
8 Configuring the terminal
8.1 Checking signal strength
page 8
⑪ Vout3, Power
A suitable emergency light and buzzer are available from AddSecure on
request.
The terminal is now installed, so the power supply can now be connected.
Switch the power on and check that the indicator "SYS LED" is flashing (top
green LED on PCBA). If it does not, you need to contact AddSecure.
The terminal does not need to be configured. All the configuration and
activation is done by AddSecure directly to the unit.
A good signal, at least 2 LEDs lit, is required in order to activate the terminal. To
see the current signal strength, press and hold the alarm button for at least five
seconds. The five LEDs will respond together, as a bar graph, to indicate the
signal strength. For example:
Low
Cellular signal
strength
When a Reflash is occurring, all the LEDs flash whilst the Reflash is
downloading and then stay on constantly during the re-programming.
This connection has 12 V output. It can, for example, be
used for the Call Connect.
Medium
Excellent
PDK-13010-v.6.0 Edge VS5010 and VS5051 User manual