DataApex Clarity SPARK MARATHON Manuel - Sayfa 8

Kontrol Ünitesi DataApex Clarity SPARK MARATHON için çevrimiçi göz atın veya pdf Manuel indirin. DataApex Clarity SPARK MARATHON 18 sayfaları. Clarity control module

Sayfayı Yazdır
Spark Marathon

3.2 Spark Marathon setup - Communication

The Spark Marathon autosampler has to be set in the SERIAL MODE in
order to function correctly with its Clarity Control module. In addition, the
ID of the Spark Marathon autosampler must be the same that will be later
set in Clarity. To set the autosampler to the SERIAL MODE and find out or
change the autosampler ID, perform the following steps:
Press the
l
the
key to enter the SERIAL MODE.
4
Press the
l

3.2.1 Connections

For the start synchronization with LC the Start output must be connected
l
with Clarity Starting cable IN.
Do not connect the digital output cable OUTnR.
l
The starting cable INn must be connected.
l
Note:
Clarity standard cable (along with further details on wiring) is described
in the Clarity Getting Started manual.
The Spark Marathon autosampler accessories include the Start marker
l
cable (15 pin Sub D connector to 2 free leads). Connect the leads on this
cable to leads on the Clarity Starting cable INx cable extension.
Consult the user manual for Spark Marathon autosamplers for details about
l
wiring and connectors on the device.
key on the Spark Marathon autosampler keyboard, and then
F
button to set the device identifier ID.
Prog/End
Fig 3: Wiring of an autosampler with AS Control module
- 4 -
3 Installation Procedure