ELRO AG400011 Hızlı Başlangıç Kılavuzu - Sayfa 5

Güvenlik Sistemi ELRO AG400011 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. ELRO AG400011 5 sayfaları. Home alarm system with smartphone app & dialer
Ayrıca ELRO AG400011 için: Hızlı Başlangıç Kılavuzu (6 sayfalar)

Sayfayı Yazdır

Step 14 – Mounting the system

Alarm Panel

Selecting a suitable location:

Mounted the alarm panel close to the door which you normally use to enter/exit your



house.

Note that the Alarm panel requires a power outlet to function properly.



Ensure the location selected a good GSM signal. You can do this by cross checking the signal



bar on your phone at that location.

The panel must not be co-located or operated in conjunction with any other nearby



transmitter or antenna.

1. Remove the back panel mounting bracket of the

GSM and mount the bracket on the wall using wall

anchors and screws.

2. Once secured, ensure the power connectivity and

reattach the alarm panel to the secured mounting

bracket.

Door/Window contact

If possible, locate sensors within 100 ft. (30m) of the panel. While a transmitter may have a range

of 350 ft. (106 m) or more out in the open, the environment at the installation site can have a

significant effect on transmitter range

1. Mount the sensor on the door frame and the

magnet on the door. If the sensor is used on

double doors, mount the sensor on the least-

used door and the magnet on the most-used

door.

2. Place sensors at least (1.5 m) above the floor for

best transmission range

3. Make sure the alignment arrow on the magnet

points to the alignment mark on the sensor.

4. Avoid mounting sensors in areas where they will

be exposed to moisture or high temperature.

5. Use spacers (not included) to keep sensors and

magnets away from metal or metallic surfaces

such as foil wallpaper.

PIR Motion Sensor

The recommended position for a PIR Detector is in the corner of a room mounted at a height

between 1.8 and 2m. At this height, the detector will have a maximum range of up to 10m with a

Keep sensors within 30 m (100 ft) of alarm panel.

field of view of 110° (see figure below).

1. Fix the motion sensor on the wall by using the

adhesive tape provided.

2. If you need to drill it on the wall, remove the rear

cover and drill through the rear cover. Drill guides

are provide for flat mount or corner mount (see

below)

3. Once the back cover is secured reattach the main body of the sensor to the back cover.

Home is not a place, it's a feeling

We hope you'll enjoy your purchase and the safety and comfort that comes with your ELRO

Alarm System. We pay close attention to the quality of our products. In addition, we find an

easy installation and user convenience very important. We are aware that there will always be

things we can improve. What these improvement are, nobody can tell us better than you.

Therefore, we would love to hear from you how your product experience was, from

installation to daily use of your alarm system. Please visit www.elro.eu and give your opinion

on our ELRO Alarm Systems. Your feedback is very welcome. On our website, you'll also find an

overview of compatible accessories and other ELRO security and comfort products that ensures

an easier and safer way of living.

We wish you a safe & happy home,

Ad Daamen,

CEO, ELRO Europe

Corner mounted

Drill for corner monuting

Drill for flat wall monuting