Datacom Systems VS-1224-F Hızlı Kurulum Kılavuzu - Sayfa 11
Ağ Donanımı Datacom Systems VS-1224-F için çevrimiçi göz atın veya pdf Hızlı Kurulum Kılavuzu indirin. Datacom Systems VS-1224-F 17 sayfaları. 10/100/1000 mb and 10 gb data access switches
Network IP Address Configuration
11
Step 11. Disconnect the DRL512-2M-R serial cable from your VS-1212-F Data Access Switch or
VS-1224-F Data Access Switch and proceed to install the VS-1212-F or VS-1224-F in your
chosen network location.
4
Stand-Alone Installation
This section will focus on a simple configuration which describes the typical VS-1212-F Data
Access Switch and VS-1224-F Data Access Switch hardware installation at the network location of
your choice.
4.1
Power Connection
Two AC input power sockets are provided on the rear panel. The front panel POWER 1, POWER 2
LEDs are illuminated green, respectively, when the AC power switch is depressed ON and AC
power is available at both the two rear AC power sockets. Either POWER 1, POWER 2 LED
illuminated
red
indicates a defective power source and immediate investigation as to the cause is
required to insure redundant power integrity.
Step 1. Using the supplied AC Line Cords, plug the VS-1212-F Data Access Switch and VS-
1224-F Data Access Switch into different circuit external power sources.Although only one power
supply is required to power the VS-1212-F and VS-1224-F, use of a second independent power
source is strongly recommended to assure uninterrupted monitoring. Furthermore, connecting the
second AC power socket to a different external power source circuit than the first AC power
source eliminates power as a single point of failure.
The AC POWER switch is a rocker style switch. The AC power switch circle icon depressed is OFF
. The AC power switch bar icon depressed is ON.
Step 2. Power ON the VS-1212-F and VS-1224-F by depressing the AC power switch bar icon.
The powered ON VS-1212-F and VS-1224-F is indicated by the illuminated
POWER 1 and
green
POWER 2 LEDs on the front panel.
© 2012 Datacom Systems Inc