Elsema iS3000 Kullanıcı Kılavuzu - Sayfa 6

Kapı Açıcı Elsema iS3000 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Elsema iS3000 8 sayfaları. High speed sliding gate opener

The limit sensor has a + marking indicating the centre of the sensor. Adjust the sensor

so that the + marking is the centre of the magnet on the gear rack.

The 2 x limit magnets should have different marking on them. One should have a

and the other should have a

same marking. The magnets can be installed on either side (open or close). Please see

the diagram below to locate the marking on the magnets.

When steel gear rack is used (or gear rack which are much slimmer), you will have to use

the packing block which comes with the limit switches. Please see the diagram below.

Once the limit switches are adjusted turn the power on to the MCiS control card and follow on

screen instructions to profile the gate. The MCiS control card has been specially configured

to be used with iS motor kit. For replacements please contact Elsema PTY.

. You cannot use the limit magnets if they have the

Polarity

Marking

Fig 6