Dusol DS72 Series Kullanıcı Kılavuzu - Sayfa 4

Solar panel Dusol DS72 Series için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Dusol DS72 Series 11 sayfaları.

2. Basic safety instructions

PV modules generate DC electrical energy when exposed to sunlight or other light sources. Active

parts of module such as terminals can result in burns, sparks, and lethal shock

Artificially concentrated sunlight shall not be directed on the module or panel.

Front protective glass is utilized on module. Broken solar module glass is an electrical safety

hazard (may cause electric shock and fire). These modules cannot be repaired and should be

replaced immediately.

Electric Shock and Burn Hazard

This photovoltaic module produces electricity when exposed to the sun

To reduce the risk of electrical shocks or burns, modules can be covered by opaque materials

during installation to avoid shocks or burns.

Solar modules create electricity and are even energized under a slight illumination level. A

series connection of modules leads to an accumulation of voltage. A parallel connection

addition leads to an accumulation of current. The wiring of several modules to a generator

control panel is only to be handled by authorized specialized staff.

Following the battery manufacturer's instructions if batteries applied.

Do not install modules where flammable gas may be present.

Do not touch live terminals with bare hands. Use insulated tools for electrical connections

Do not remove any part of the module installed or disassemble the module.

All instructions should be read and understood before attempting to install, wire, operate and

maintain the module.

Please do not lift up PV modules by lifting up the connected cables or the junction box.

All PV systems must be earthed.

Never open the junction box of the photovoltaic module.

Under normal conditions, a photovoltaic module is likely to experience conditions that

produce more current and/or voltage than reported at standard test conditions. Accordingly,

the value of Isc and Voc marked on this module should be multiplied by 1.25 when

determining component voltage ratings, conductor current ratings, fuse sizes, and size of

controls connected to the PV output.

DUSOL Solar Photovoltaic module

MADE IN DUBAI