Elsner KNX PS640+ Kurulum ve Ayarlama - Sayfa 4

Güç Kaynağı Elsner KNX PS640+ için çevrimiçi göz atın veya pdf Kurulum ve Ayarlama indirin. Elsner KNX PS640+ 16 sayfaları. Power supply systems with bus functions

Sayfayı Yazdır

BCU type

PEI type

Group addresses

Allocations

Communication objects

The following standards have been considered for the evaluation of the product in

terms of electro magnetic compatibility:

Transient emissions:

EN 60730-1:2000 Section EMV (23, 26, H23, H26) (threshold category: B)

EN 50090-2-2:1996-11 + A1:2002-01 (threshold category: B)

EN 61000-6-3:2001 (threshold category: B)

Interference resistance:

EN 60730-1:2000 Section EMV (23, 26, H23, H26)

EN 50090-2-2:1996-11 + A1:2002-01

EN 61000-6-1:2004

The product has been tested for the above mentioned standards by an accredited EMV

laboratory.

Installation and Commissioning

Attention! Mains voltage! The legal national regulations

must be complied with.

Installation, inspection, commissioning and troubleshooting of the power supply

system must only be carried out by a competent electrician. Disconnect all lines to be

assembled, and take safety precautions against accidental switch-on.

The power supply is exclusively intended for appropriate use. With each inappropriate

change or non-observance of the instructions for use, any warranty or guarantee claim

will be void.

After unpacking the device, check immediately for any mechanical damages. In case of

transport damage, this must immediately notified to the supplier.

If damaged, the power supply system must not be put

into operation.

If an operation without risk may supposedly not be guaranteed, the plant must be put

out of operation and be secured against accidental operation.

The power supply system must only be operated as stationary system, i.e. only in a

fitted state and after completion of all installation and start-up works, and only in the

environment intended for this purpose.

Elsner Elektronik does not assume any liability for changes in standards after

publication of this instruction manual.

Own micro controller

max. 200