Cayken KCY-520WEQ Kullanım Talimatı - Sayfa 9

Araçlar Cayken KCY-520WEQ için çevrimiçi göz atın veya pdf Kullanım Talimatı indirin. Cayken KCY-520WEQ 16 sayfaları.

4.Fix the host machine according to the progressing mark on it.Fix the speed control,the

plug and the handwheel rotating in counter-clockwise and then the host machine can run

on the track way.

5.Fix the saw web.The diameter of the internal hole of the host machine is 355mm.The

hexagonal screw to fix the saw web must be fastened by the open and wrench.

6.The saw web aims at the cutting plane line.Fix the track way totally,adjust flatly the six

hexagon heads on the track way with the hexagon spanner and move up and down the

screws to be on the same horizontal line. Thus the track way can not break away from

the joint.

7.Aim at the plug connecting the cable. B.Cutting instructions

8.Insert the water pipe into the inlet valve to supply water.Regulate the water and make it

abundantly on the cutting plane.

9.Turn on the switch on the control cabinet and the switch on the control cabinet and the

switch of the host machine.

10.After rotating the cutter handwheel,in start cutting slowly.The saw web move downwards

to touch the cut parts.The saw web must move slowly.When the cuts to the preset

depth,rotate the handwheel to cut.(then you should turn on the machine's switches

for moving up and down or forward,adjust the speed and make electric cutting.)You

can adjust the cutting speed when it cuts into the wall.The cutter must keep a low and

uniform velocity when coming into reinforcing steel bars.If it cuts too deep at the

beginning,it is excessive work for the machine,which will decrease the cutting speed.

11.Dissemble the host machine from the track way and clean up the working area after

the cutting.

Notes when the cutter is working:

a.If the cut part is hard and thick,the best way is to cut it twice.That is, if the cut part is

20cm thick,cut into 10cm first and then cut into 10cm again.In this way,it will raise the

cutting efficiency,and reduce the spoilage to the saw web.

b.Do not plug in when fixing or dissembling the saw web in case of accident.

c.The machine can not work over 10hours every day.It is better to cool it for a while after

it keeps working for two or three hours and then it can work again.

FITTINGS

The track has two sizes of 1.2m and 1.8m.The user can order other size of track way

accordingly.