Cayken SCY-420WEQ Kullanıcı Kılavuzu - Sayfa 4
Kesici Cayken SCY-420WEQ için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Cayken SCY-420WEQ 9 sayfaları. Wall cutter
Sayfayı Yazdır9.Install proper parts in the proper position
Make sure that the cutting device and fittings are installed in
the correct position.It is in correct to use the machine equipped
with no fittings or to fix the fittings too tightly or loosely
by using unspecified tools.Do not dissemble any screws or covers
at will for the safety of the machine.
10.Check every part carefully before use
Do not forget to take away the wrench and screw driver for they
will be forcefully flicked away when the machine starts.It is
very dangerous.
Keep a good habit to make sure that all the installation kits are
removed away when the machine starts.
11.Keep the intake motor smooth
The intake is indispensable for cooling of the motor.It is
incorrect and unallowed to cover the intake to protect it from
dust.In addition,do not insert metallic needles and the like.It
may result in electric shock.
12.Wear safety goggles to protect eyes
Wear safety goggles in operation.
13.Keep the balance of the controlling machine balance
Unstable and unbanlancing operation is dangerous.The operator
must have stable steps and good equilibrium sense at any moment.
14.Use rated power supply
Use the machine according to the rated power supply.If the
current the machine uses exceedsthe rated voltage,it will cut
down the efficiency.
And
abnormal
accelerated
machine.(The electrical current should be controlled at6A,not
exceeding 10A)
15.Do not use your machine with excessive force
Do not use your machine or fitting for the purpose of not their
functions.
Excessive force will not only damage the rigidity of the cutting
objects and the number of the reinforcing steel bars.
16.After the machine plugs in
After the machine plugs in, do not put your fingers on the
switch,in case of danger.
17.When the machine is running
When the machine is running,do not put your hand beside the saw
web.
18.Stop operating when finding the machine is wrong
motion
will
finally
break
3
Stop operating and inform the maintenance man when finding the
machine is wrong.
19.Do not plug in when not using the machine
The appliance must be unplugged after use or before changing the
cutlery and fittings or at power cut.Keep a right habit to make
sure that the machine is off before plugging in.
20.Do not use the electrical wire incorrectly
Do not pull the wire of the machine like a knob or pull out the
wire from the interface fiercely,which will cause power cut or
short circuit.Keep the wire away from the cutlery or dangerous
place such as hot gas and so on.I f wires are broke,stop
operation and inform the electrician to change or repair it.
21.Keep the machine properly
Please do not knock the machine,or else it will damange the
machine or reduce its working efficiency.
22.The use of the cutlery
Keep the cutlery edge clean,sharp and trim.
23.Maintain the machine carefully
Keep the machine tidy,especially the motor away from dust.Keep
the electrical wires from oil to prevent it from injured.
24.Check the machine regularly
Check the machine regularly for safety
25.Check and maintain the machine in the service centers
authorized by the company
the
If the machine needs maintainance,please contact our agents or
service centers Change the parts into those made from the
original manufacturer.
26.Keep the machine carefully
Put the machine in dry and safe place when it is not in use.Put
it in the place out of the reach of children.Avoid moist or rainy
place.
4