Cayken SCY-420WEQ Kullanıcı Kılavuzu - Sayfa 8

Kesici Cayken SCY-420WEQ için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Cayken SCY-420WEQ 9 sayfaları. Wall cutter

Sayfayı Yazdır

by the concrete when cutting,thus decreasing the cutting

efficiency.If they are not parallel,loosen the 4 set screw of two

speed box on the middle base with hexagon spanner of less than

6mm and adjust depth of parallelism of the saw web.

4.Check the carbon brush

The motor contains dissipative carbon brush,If the carbon brush

is seriously worn,it will wear the motor.

When the carbon brush is frayed to only 6mm,it needs to change a

new carbon brush.Keep the brush clean, so that it can be easily

put into the carbon brush box.

Note:

Keep

changing

the

manufacturer. Nip tightly the power line when changing the

carbon brush.

5.The motor's protection

The motor is the heart of the machine. Be careful.Do not let oil

or water into the motor.

Notes: If dust or things come into the motor.the motor may be

dam-

aged.Make the motor run no-load to eject the dust after each use.

6.Check the screws on the machine

Check whether the screws on the machine are loosed.If they

are,fasten them.It is very dangerous to use machine with loosed

screws.

7.Keep the machine or fittings

Keep the machine or fittings in dry and safe place.Do not place

them in the following places:

a) Place in the reach of children

b) Moist place

c) Place where the temperature is labile

d) Place exposing directly to the sunshine

e) Flammable or explosive place

carbon

brush

from

the

original

Chapter10. Maintenance Notes

First.the

machine

system.Thereby,if your machine is broken, do not repair it by

yourself but contact our franchiser or us for repair.

Second.it is prohibited to personally change parts not from the

original producer.If you do, we will charge the total repairing

fees after it is verified.For example,if you change the carbon

brush not from the original producer,the resistance may be too

large or small for the machine for it is not from our factory.

It may result in the damage to the motor cover and others,and

even leads to the burning of the motor.For the sake of protecting

the machines's service life,we prohibit the customer to

personally change parts not from the original producer.Thank you

for your cooperation.

Annotations:Clean up and lubricate every thread rolling dies and

wheel for every 200 hours' using the cutter.

made

under

normal

producing