elsner elektronik 70361 Teknik Özellikler ve Kurulum Talimatları - Sayfa 8
Aksesuarlar elsner elektronik 70361 için çevrimiçi göz atın veya pdf Teknik Özellikler ve Kurulum Talimatları indirin. elsner elektronik 70361 9 sayfaları. Temperature sensor
Sayfayı Yazdır
Eco mode.
Night target temperature will be
used.
Heating mode.
Heating will be provided.
Priority (points)
One point: Priority 1/priority control. It is not possible to adjust the temperature auto-
mation system manually. Neither the target temperature nor the operating modes can
be changed using the buttons on the unit.
Two points: Priority 2. The target temperature and operating mode can be changed us-
ing the buttons.
3.2. Change ambient temperature with the
buttons
If the mode display is active, the target ambient temperature and the operating mode
can be changed manually using the buttons. The button functions can be blocked in
the ETS or be suppressed for Priority 1 operating modes. The individual operating
modes can also be locked for manual selection in the ETS.
Decrease target
temperature (-)
Increase target
temperature (+)
Fig. 8
In "HVAC mode with 2x 8 bits" control mode, points are
shown under the symbol, to indicate the running priority
of the current mode.
briefly press
left button
briefly press
right button
Temperature sensor KNX T-B-UP • Software version 3.1 and higher
Status: 21/03/2016 • Technical changes and errors excepted.
8
Display and operation at the device
Building protection mode.
Building protection target tem-
perature will be used. The sym-
bol will blink when the mode
has been activated but the acti-
vation delay has not yet expired.
Cooling mode
Cooling will be provided.
Ambient temperature in the current
mode is decreased.
The sep-size is defined in the ETS
(0.1°C to 5°C).
Ambient temperature in the current
mode is increased.
The sep-size is defined in the ETS
(0.1°C to 5°C).