CB2 ASH Montaj Talimatları - Sayfa 3

İç Mekan Mobilyaları CB2 ASH için çevrimiçi göz atın veya pdf Montaj Talimatları indirin. CB2 ASH 4 sayfaları. Bath cabinet

Sayfayı Yazdır
ash
BATH CABINET
Fit dowels of top panel into corresponding holes
6
of right side panel and secure cams.
Fit hinges of each door onto corresponding
hinges of side panels and tighten with
8
pre-attached screw, using a screwdriver.
Made in Vietnam - r04
right side
panel
Refer to Hinge Adjustment
diagram for adjusting the
alignment of the door hinges.
door
Customer Service 800.606.6252 | Latest instructions available at www.cb2.com
With the assistance of another adult, fit dowels
of side panels into corresponding holes of leg
7
assembly and secure cams.
WALL
Determine the final location of unit. With the
assistance of another adult, position unit upright
against wall and mark the 2 holes position in the
back panel. Set unit aside. Drill a hole in the wall
stud. If a wall stud is not available, drill a hole in the
wall that is slightly smaller in diameter than the
anchor. Gently tap the plastic anchors until the
flange of the anchor is flush with the wall. Align
holes of wall and unit. Insert 2 large screws
through the back panel and into the wall anchor in
9
the wall.
leg
assembly
Page 3 of 4