CB2 FACET Montaj Talimatları - Sayfa 4

İç Mekan Mobilyaları CB2 FACET için çevrimiçi göz atın veya pdf Montaj Talimatları indirin. CB2 FACET 4 sayfaları. Bookcase

facet

BOOKCASE

WALL

For added safety and stability, it is recommended that the wall mounting

hardware be installed. For safe mounting, it is essential to use wall anchors

appropriate to your wall type (i.e. plaster, drywall, concrete, etc.). Mount to

wood studs whenever possible.

A) Attach 2 mounting brackets to top of unit using 1 small screw per

bracket.

B) Determine the final location of unit. Mark position on the wall,

approximately 2" below each mounting brackets mounted to the back of the

unit.

C) Drill a hole in the wall stud. If the wall stud is not available, drill a hole in the

wall that is slightly smaller in diameter than the anchor. Gently tap the plastic

anchor until the flange of the anchor is flush with the wall.

D) Attach the mounting brackets to the wall by inserting 1 large screw

through each mounting bracket and into the wall anchor in the wall.

E) Position the unit so the mounting bracket on the back edge is allowed with

the wall bracket.

F) Lace one end of each wall strap through corresponding brackets, and into

the other end of the strap.

G) Pull the straps tightly until secure.

Wall mounting assembly is now complete.

Made in Vietnam - r04

NOTE: Bookcae case be

wall mounted from either side

Customer Service 800.606.6252 | Latest instructions available at www.cb2.com

NOTE:

If you are unsure about your wall

type or what mounting method

you should use, consult a

qualified professional or your

local hardware store.

Page 4 of 4